/dts-v1/;
#include <st/g0/stm32g0b1Xb.dtsi>
#include <st/g0/stm32g0b1k(b-c-e)ux-pinctrl.dtsi>

/ {
	model = "EWS Board STM32G0B1KBU6";
	compatible = "ews,ews";

	chosen {
		zephyr,console = &cdc_acm_uart0;
		zephyr,shell-uart = &cdc_acm_uart0;
		zephyr,sram = &sram0;
		zephyr,flash = &flash0;
		zephyr,canbus = &fdcan2;
	};

	leds {
		compatible = "gpio-leds";
		status_led: led_0 {
			gpios = <&gpiob 4 GPIO_ACTIVE_HIGH>;
			label = "Status LED";
		};
	};

	pfets {
		compatible = "gpio-leds";
		pfet1: pfet_1 {
			gpios = <&gpioa 8 GPIO_ACTIVE_HIGH>;
			label = "PFET1 Control";
		};
		pfet2: pfet_2 {
			gpios = <&gpiob 2 GPIO_ACTIVE_HIGH>;
			label = "PFET2 Control";
		};
	};

	aliases {
		led0 = &status_led;
		pfet0 = &pfet1;
		pfet1 = &pfet2;
	};
};

&clk_hsi {
	status = "okay";
};

&pll {
	div-m = <1>;
	mul-n = <8>;
	div-q = <2>;
	div-r = <2>;
	clocks = <&clk_hsi>;
	status = "okay";
};

&rcc {
	clocks = <&pll>;
	clock-frequency = <DT_FREQ_M(64)>;
	ahb-prescaler = <1>;
	apb1-prescaler = <1>;
};

&fdcan2 {
	pinctrl-0 = <&fdcan2_rx_pb0 &fdcan2_tx_pb1>;
	pinctrl-names = "default";
	bit-rate = <500000>;
	bit-rate-data = <2000000>;
	status = "okay";
};

&usb {
	pinctrl-0 = <&usb_dm_pa11 &usb_dp_pa12>;
	pinctrl-names = "default";
	status = "okay";
	cdc_acm_uart0: cdc_acm_uart0 {
		compatible = "zephyr,cdc-acm-uart";
	};
};

&gpioa {
	status = "okay";
};

&gpiob {
	status = "okay";
};

&flash0 {
	partitions {
		compatible = "fixed-partitions";
		#address-cells = <1>;
		#size-cells = <1>;

		boot_partition: partition@0 {
			label = "mcuboot";
			reg = <0x00000000 0x00002000>;
		};
		slot0_partition: partition@2000 {
			label = "image-0";
			reg = <0x00002000 0x0001E000>;
		};
	};
};